ddloc
New Member
Posts: 4
|
Post by ddloc on Nov 20, 2017 20:45:00 GMT -5
Dear Ogi,
Thank you very much for your useful information. I will try it.
With best wishes, Loc
|
|
ddloc
New Member
Posts: 4
|
Post by ddloc on Nov 16, 2017 21:26:03 GMT -5
Dear Ogi,
My annealing temperature is 450K and I investigate the properties of samples from 450K to 10K. My Hall model is CRX-VF.
Thank you for all your help in advance.
With best wishes, Loc
|
|
ddloc
New Member
Posts: 4
|
Post by ddloc on Nov 15, 2017 9:12:40 GMT -5
Dear all,
I have a question about the grease used for a broad temperature range. I am working on a Hall machine (Lake Shore) at a temperature range of 10K to 250K.
What is the best grease for that temperature range? I need to anneal my sample in vacuum and measure it at low temp.
Thank you for all your help in advance.
With best wishes, Loc Duong
|
|
ddloc
New Member
Posts: 4
|
Post by ddloc on Mar 29, 2017 19:39:22 GMT -5
Dear all,
I am using probe station CRX-VF probe station. I read the manuall fot he probe configuration. IThe tip temperature is 45K. In such case, if I contact the tip to the sample, what is the real temperature of the sample if I set the sample stage 300K (assuming the temperature of the sample and sample stage is the same without tip)?
Is it possible to control the tip temperature or set the temperature of the tip similar to the sample stage?
Thank you for all your help in advance.
With best wishes,
Loc
|
|