|
Post by bikash504861 on Feb 12, 2020 1:04:35 GMT -5
I followed the procedure suggest by you and now the communication is successful between 240 module and measure_link_software. Issue is with the older version of measure_link_software.
In steed of using older version of measure_link software, I used new version of measure_link software (i.e. measure_link_for_240series_V10.0 prototype) in which successful communication is established.
Thanks for your kind-support and co-operation.
|
|
|
Post by bikash504861 on Oct 27, 2017 0:25:42 GMT -5
I am waiting for your reply.
|
|
|
Post by bikash504861 on Oct 24, 2017 7:37:56 GMT -5
I followed the step as per guideline given in your document. But still issue is not yet resolved. however, communication has been established through tera term . Serial no. info as per doc was displayed as we write *IDN? (as per attached screenshot) Three screenshot are attached 1. baud rate setting (device manager) 2. successful serial information displayed through tera term 3. error pop up message when tera term software was open in PC when we close tera term software, if we try to connect measure link software then it connects for few second and automatically disconnect and same error pop up message (disconnect) comes which we have told you earlier In this way, we can receive information through tera term but issue with measurelink software is not resolved so far. We kindly request you to needful to resolve this issue. Attachments:
|
|
|
Post by bikash504861 on Oct 23, 2017 1:22:21 GMT -5
Thanks for reply. Here I am attaching the screen shot of error message.
|
|
|
Post by bikash504861 on Oct 18, 2017 7:25:55 GMT -5
First of all thanks for reply.
As far as COMM port is concern, YES port is configured in device manager and same is reflected in measure link software. But still it shows error message after few seconds "device is disconnected try again later".
Thanks in advance
|
|
|
Post by bikash504861 on Oct 17, 2017 1:10:33 GMT -5
Lakeshore transmitter 240-8p not responding through USB cable, but it is communicating through profibus cable. When we connect USB cable to lakeshore transmitter through measurelink software, it shows error, and communication is not possible through USB cable. But when we check the temperature values in SCADA( through profibus ), it shows actual temperature values.
This is the problem, i need your help to resolve the problem. Thanks in advance
|
|