|
Post by silentsailor on May 17, 2019 16:58:07 GMT -5
Hi,
I am writing an application that controls a 155 I/V source via SCPI. After a while the display's auto-dimming kicks in and I can't figure out how to light up the display. I tried the SCPI commands to adjust the brightness and turn the display on and off without any luck. Is this feature available?
-Andy
|
|
|
Post by Lake Shore Ogi on May 20, 2019 9:22:19 GMT -5
Dear Andy,
There is at the moment no way to turn this off but I've let our engineers know to consider this in a future firmware update. Currently, the timer is set to 30 minutes and the display needs to be touched to bring it to light back up.
Greetings, Ogi K.
|
|
|
Post by silentsailor on May 21, 2019 16:09:10 GMT -5
It would be helpful. I really don't want the operator touching the display every time it goes dim. I've implemented the keyboard lock command so they won't accidentally turn something on/off while re-enabling the display.
I think I would be okay if the display always auto-timed out and there was a way to "simulate" touching the display, thus resetting the time out counter.
thanks,
Andy
|
|