Post by tomer on Jul 3, 2019 4:44:17 GMT -5
Hello all,
I'm looking to mount a TG-120P thermometer sensor. I read in the installation instructions that it is recommended using grease.
For better mechanical anchoring, I would like to use epoxy to glue the sensor to the device (inside a designated hole).
Is it advisable to use epoxy? If so, can you recommend the specifications for the desired epoxy?
Thanks,
Tomer
I'm looking to mount a TG-120P thermometer sensor. I read in the installation instructions that it is recommended using grease.
For better mechanical anchoring, I would like to use epoxy to glue the sensor to the device (inside a designated hole).
Is it advisable to use epoxy? If so, can you recommend the specifications for the desired epoxy?
Thanks,
Tomer
