Post by actionjack on Jan 26, 2020 21:25:55 GMT -5
Hello folks. I'm trying to communicate with my Teslameter in Labview and while I would normally ask labview people, this particular error seems to a device specific error but I cannot find in the manual what -310 means exactly. I thought I might have read somewhere that it had to do with me querying data that the device wasn't setup to give however, I have it in AC mode and the unit type is set to Tesla.
I hope this question is not out of the scope of this forum since I'm using Labview but I am really just sending scpi commands with it and getting this device specfic error which I'm sure someone here knows about. Thank you.