Post by earan on Jan 14, 2021 17:53:55 GMT -5
Hi,
I'm looking for some advice on thermocouple wire termination..What is the best method to terminate a type E thermocouple extension wire on an electrical feedthrough? Do you recommend a specific flux/solder to use? When using a typical Sn 60/Pb 40 solder and RMA flux, the thermocouple wire tends to fall out of the solder cup.
Thank you,
Emily
I'm looking for some advice on thermocouple wire termination..What is the best method to terminate a type E thermocouple extension wire on an electrical feedthrough? Do you recommend a specific flux/solder to use? When using a typical Sn 60/Pb 40 solder and RMA flux, the thermocouple wire tends to fall out of the solder cup.
Thank you,
Emily
