mikec
New Member
Posts: 6
|
Post by mikec on Feb 10, 2023 14:43:09 GMT -5
Can I display the electrical information (Volts, Current, or Watts) of heater outputs (1 & 2, or analog 3 & 4) on the front panel of the Lake Shore 336?
Also, can I remotely acquire the electrical information directly from the unit using the available SCPI commands?
|
|
|
|
Post by Lake Shore Jeff M on Feb 10, 2023 14:49:22 GMT -5
You can display the heater diagnostic information for Outputs 1 & 2 on a Model 336 Controller by holding the Display Format Button in for approximately 5 seconds When the controller beeps, release the keys and you will see the real time information for both outputs.
At this time, none of the diagnostic information is available thorough the command interface.
|
|
mikec
New Member
Posts: 6
|
Post by mikec on Feb 13, 2023 11:50:25 GMT -5
Thanks for the information Jeff. I really appreciate it (...now on to the next mystery  ) |
|
)